Hardwood and flowers make a nice day! Early yesterday morning we set off for Salt Lake City, to visit the MacBeath hardwood store. This sort of trip was one of the main reasons I bought my utility trailer, and I was very pleased to see how well it worked for the job. I was hoping to get red oak for my framing wood, but even MacBeath didn't have enough. In fact, the only reasonably strong hardwood they had in stock in sufficient quantity was yellow poplar. That's not an ideal choice, but it should be plenty strong enough for my job. I got 45 pieces of random length 1x4s, all between 11' and 12' long. That's a lot of hardwood! I had been planning to use oak 1x3s, but moving to 1x4s will make the poplar frames very nearly as strong as the smaller oaken frames. Below the poplar sticks are eight sheets of Baltic birch plywood. These are all “cabinet grade”, meaning no patches, no knots, and no interior voids. Both faces of each sheet are birch, though one side is better quality. I only care about both sides on some of the 1/4" thick sheets, and I got lucky on them: both sides of those sheets are darned near perfect. When I got done loading the trailer, the guy at MacBeath helping me estimated the weight at 600 lbs. The trailer behaved well, most especially at highway speeds. For the portions of our trip along I-15 north of Ogden, we were traveling at a steady 80 mph, and the trailer acted like it was glued to the road. It only got bouncy on some very rough city streets in Salt Lake City. Very nice! Oh, and the Tesla didn't feel any different at all driving with the loaded trailer. I couldn't detect any difference in performance, except for the battery consumption (roughly 20% higher than with no trailer, though only at highway speeds).
After we got home and got the lumber unloaded, we went to Rudy's Greenhouse to find some color for our porch and balcony pots. We picked out seven of their hanging baskets, which we're going to just steal the plants from. So pretty! Transplanting these is on the agenda for this afternoon...
No comments:
Post a Comment